Just a quick one that maybe someone on here knows the answer to - this forum is a bit more friendly than Mikrotiks.I have my routing that has two PPPoE WAN interfaces on it. Lets say they are pppoe-wan1 & pppoe-wan2The first interface (pppoe-wan1) is just for the entire network (192.168.2.0/24), the other (pppoe-wan2) I just want one host (192.168.2.250) to go out over it.From reading, and from my general thoughts, I thought it would be fairly simple and did the following....- Create Mangle rule. - Chain: prerouting, src address: 192.168.2.250 - Action: mark routing, new routing mark: server_host- Create second 'default' route but only for marked traffic. - dst address: 0.0.0.0/0 - gateway: pppoe-wan2 - routing mark: server_host- Add another NAT masquerade rule to NAT single host to the second gateway - Chain: src nat - Src addr: 192.168.2.250 - Out int: pppoe-wan2 - Action: masqueradeNow the issue I am seeing is that as soon as I enable the Mangle rule I loose connectivity to the host. When I try to load the web page on the server I see the packet counters go up by the Mangle rule so it is obviously matching packets. But, as I mentioned, I never actually get connectivity to it unless the mangle rule is disabled.Any one got any pointers and where I am going wrong? Going a bit mad reading different wiki's and forum posts!
↧