I have fortigate 60D at home.. Just bought Netgear 4G modem with 2 degree sim card.. for data conneciton.. I have connected to USB but it is not getting connected.. following are the details. product: http://www.netgear.com/service-providers/products/mobile/usb-modems/320u.aspxon the firewallFGT60D4614054581 # diagnose sys modemThe modem state is 6, poll rate is 180000.The modem is not active.FGT60D4614054581 # diagnose sys modem external-modemExternal modem vendor: SierraExternal modem vendor id: 1199External modem model : AC313UExternal modem product id: 68aaHowever the product is Airbus 320U .. on the back of the modem.. I have read some blog and it say it may use different port number even though it share same product ID.. I couldn't find any configuration though.. is there any chance someone can share some expertise to get this configuration corrected..Configuration:FGT60D4614054581 (modem) # showconfig system modem set status enable set auto-dial enable set redial 1 set phone1 "*99#" set extra-init1 "at+cgdcont=1,\"ip\",\"wap.telecom.co.nz\"" set altmode disableendErrors:modemd: redails:1 isp:0 dev:/dev/ttyusb0 tel:*99#modemd: run_state_machine state 0(uninit)modemd: modem state changed: 0(uninit) -> 1(inactive)modemd: Launch modem due to auto-dial.modemd: Begin dialing: redials left = 1modemd: dev=/dev/ttyusb0 tel=*99#modemd: modem state changed: 1(inactive) -> 2(dialing)chat: abort on (BUSY)chat: abort on (NO DIAL TONE)chat: abort on (NO DIALTONE)chat: abort on (NO ANSWER)chat: abort on (ERROR)chat: send (atz^M)chat: expect (OK)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)modemd: run_state_machine state 2(dialing)
↧