Hi All With the good help of people on this forum I have successfully run about 300 metres of cat 6 around the house terminating back to my study. Still need to buy a patch panel but am immediately looking at the various keystone jacks and faceplates. I originally settled on dynamix faceplates and keystones but a friend indicated PDL also do a range. I have the PDL 600 range in my home for power and lighting so thought it made sense...However...I'm struggling to source the correct components and wanted to check.Can some helpful person point me in the correct direction for what I need re the PDL range. I'm guessing600 series FaceplateKeystone jacks ( Dynamix or another brank)An accessory clip so that the dynamix snaps into the PDL fitting ?Do I need a backplate that everything attaches into and the faceplate simply clips over it or is everything integral to the faceplate etcAlso, I have used standard flush mounting back boxes and the cable simply exits through the hole in the front. Is there a benefit to using 90 degrees versus 180 degree keystone jacks...In a domestic install what's easier to wire at the wall ?Finally I currently still have copper and the old style BT sockets. I'm presuming I can plug the phones into the new rj45 sockets and take care of the patching at the switch etcThanks for any help or other advice if Ive missed somethingCheers Ged
↧