PPPoE config on a Bigpipe ADSL

Hi GZ !I try to connect to my ISP Bigpipe who had gently activate PPPoE on my adsl connection.The goal is to avoid a double NATand learn some stuff about networking.The infos from BigPipe are :

We have set up your line for PPPoE login now.

Can you please try to reconfigure your settings as follows

VPI: 0

VCI: 110

PPP Protocol: PPPoE

Encapsulation: 802.1Q

VLAN ID: 10

PCP / QoS Marking: 0

PPP Username / password: anything, just not blank.

My lan is 192.168.26.0/24 In first Modem side (DG834G v4 - Modem mode): Nothing else on modem... This modem is pluged in the WAN port of my R7000 running DD-WRT Second point, DD-WRT, what I did... Setup / Basic Setup Setup / Vlans Setup / Networking I never get WAN IP address from the modem. I think I miss something... But the network, especially PPP, is really not my area of skill...Every advice are welcome.Cheers,