Currently with BigPipe, only able to get ADSL at my address and the speeds aren't great (max of approx. 12mbit down, 2mbit up).I tried out Skinny Broadband over 4G which was much better (approx. 40mbit up and down), but the 100GB cap is insufficient. I have ethernet cabling run throughout my house, and current setup is as follows:Draytek Vigor 120 into Ubiquiti Edgerouter X SFP. Off this is a Unifi UAP-AC, and a couple of hard-wired devices (home server, dlink switch which a couple of gaming consoles are connected to).What I am considering, is re-joining with Skinny, configuring a second WAN interface on my Edgerouter and running the Skinny modem into that. I understand this requires double-NAT'ing, but don't know exactly what configuring this entails.I would ideally then have DHCP set up to use the existing BigPipe connection, or I can manually configure to use the Skinny connection on certain devices, but have all connections able to communicate within the LAN, and all WiFi devices using the Unifi AP.Is this possible (with my current hardware)?
↧