After a little advice please.I'm slowly upgrading my networking equipment at home. Yesterday my shiny new USG arrived and, after some initial hair-pulling (turns out it can only be adopted if the controller is on 192.168.1.X, which mine wasn't) I've got it connected and have internet throughout the house.As a way of explanation, the following is how I have things set up:ETP --> V130 --> USG --> un-managed switch --> rest of house (RPi running Unifi controller, 2 Unifi AP's etc) The V130 is in bridge mode, ADSL2/2+, @192.168.1.2 and the USG is doing the work @192.168.1.1. I would like to be able to access the V130 from within the LAN without removing cables etc to do so - I realise that it will be a rare thing that I need to get into it, but still. I have read some stuff about VLan tagging but it all seemed to apply to VDSL as opposed to ADSL, so left me a little confused. Any advice would be greatly appreciated, thanks.
↧