Hi guys I'm unsure if i have done my half bridge setup correctly. I did my setup following an old guide from http://www.ben.geek.nz/2006/11/adsl-routing-solution-in-detail/ My current setup is the tp link 8840 and 1043nd router running gargoyle custom firmware. Unfortunately due to my limited knowledge and the guide using different modem, router and custom firmware for the router, it was difficult for me to make sure that i have done everything correctly. The only change i recall doing to the modem was: Updating the firmware Changing the ip range of the modem to 10.0.0.1 Enabling ip extension I've read online that if set up properly in half bridge mode, you should not be able to access the web interface of the modem. Strangely I am occasionally able to access it from 10.0.0.1 wirelessly for short period until it randomly disconnects me telling me the webpage is not available. Some posts on the forum also suggests that the DHCP to be disabled for the 8840 for half bridge, but I could not locate anything related to the DHCP on the modem for some reason...... The user guide I found from tp link shows a slightly different interface to mine. Cheers
↧