TP Link Archer C7 & firmware 160712 & Vodafone FibreX

Hello,

I got Vodafone FibreX put on and initially had trouble accessing overseas content via my Samsung SmartTV (BBC iplayer, ITV) after swapping over to my TP-Link Archer C7 router. It would usually take several attempts to successfully launch video via the iPlayer. When I swapped back to the Vodafone HG659 router the BBC iplayer worked well.

When I set up the Archer C7 router I downloaded a BETA firmware that would enable VLAN tagging ID values of 10. Without this the Archer C7 would not work with FibreX as the VLAN tagging ID values of the former firmware had a minimum of 16.

It seemed to me that this BETA firmware may have been the problem with poor perfomance. Some weeks went by and TP-Link released a new firmware for Australia & New Zealand.

My Archer C7 is hardware Version 2, and I tried the new firmware Archer C7_V2_160712_AU&NZ (Firmware Version 3.15.1 Build 16712 Rel.57168n)

Although I was successful in connecting the Archer C7 with The BETA firmware to Vodafone FibreX, I have not been able to connect to FibreX using Firmware 160712 (which is supposedly optimized for Fibre Optic and FibreX).

I have talked to Vodafone Tech support and my settings sound correct to them.

As my FibreX account has a static ip, I have the following settings:

WAN Connection Type: Static IP

IP Address: 203.XXX.XXX.1 (Confirmed Correct by Vodafone)

Subnet Mask: 255.255.255.0

Default Gateway: same as IP Address

MTU Size (in bytes): 1500

Primary DNS: 203.109.191.1

Secondary DNS: 203.118.191.1

VLAN page

IGMP Proxy: Enable

Mode: NZ UFB

VLAN TAG for Internet Service: Enable

Internet VLAN ID: 10

Internet VLAN Pri: 0

I tried enabling and disabling IPv6 Support, but that made no difference: 0 packets received.

I'm hoping somebody out there has the Archer C7 on firmware 160712 working happily with Vodafone FibreX and tell me where I am going wrong.

Many thanks,

Tim