Hi All,Just had fibre installed and am connecting up my phone line from the ONT to my structured cabling solution which uses the Dynamix Bridged Telecom Module (HBG-1008) and have no dial tone. It was working fine with my old copper line that came via cat6 and master splitter at the ETP.I have chopped the end off the cable (rj11->rj11 6 core) the chorus left me to punch down and have followed the guide http://www.notjustcables.co.nz/pdfs/hbg1008.pdf and still no luck. I have also read this post too https://www.geekzone.co.nz/forums.asp?forumid=39&topicid=208637 which is similar in topic.I have checked that I am plugged in to the POTS1 port on the ONT and also plugged phone directly in to this and the line is correct/working.I have attached the image below for a second set of eyes to check I have it correct and will double check my punch downs.Appreciate your guidance.
↧