Hi everyoneI am trying to configure the MikroTik RB750gr3 to be a ppoe bridge to a firewall, so that the firewall will have the public IP at the WAN interface with full control of traffic, port forwarding and HAproxy rules.The RB750 will be on a gig fiber connection with Connection: UFF-ONT -----> (eth1) RB750 (eth2) -----> (WAN) firewall (LAN) ----> devices.I have managed to get ppoe working but i cant seem to get the ip address to pass through the mikrotik to the wan interface on the firewall, I have had a poke around in threads here and on google but most people are just using them for the Vlan tagging for older hardware.To get it to where I am I have been using winbox to configure the rules/settings and get it to the point that i am at but i just cant quite figure it out.I am new to MikroTik product and RouterOS so not 100% sure the correct setup or if this is even possible, Im sure that it would be possible some how.So if there are ant RouterOS guru's or MikroTik gurus that could shed some light on this it would be greatly appreciated.Thanks
↧