Help with bridging Spark VDSL into Grandstream GWN7000

Hey guys,

I am trying to setup for a colleague a VDLS connection running into a Spark Modem then into a Grandstream GWN7000 Router (an access point is connected into the Grandstream router). I have followed the below guides from both Grandstream and the Spark support page but I do not appear to be able to get a connection to the internet.

Bridge on HG659B

Login to your the HG659/HG659b interface.

Click Internet from the top menu

Click Internet Settings from the left menu

Locate and select your connection type

VDSL connection: INTERNET_TR069_VDSL_VID_10

Fibre connection: INTERNET_TR069_ETH_VID_10

Click Edit

Change the following settings:

Service type: Tick only INTERNET (ensure both TR069 and Voice are unticked)

Connection type: Bridged

Click Save

Click OK at the warning message

On the Grandstream Router I then do the following:

Connect the cable between the LAN port of the HG659/HG659b and the WAN port of the third party router

Configure your third party modem setting by completing the following steps:

Configure the WAN connection settings on your 3rd party router:Note: if you require help with this part please refer to your router's vendor for support.

PPPOE username: user@xtrabb.co.nz

Password: password

Turn off VLAN and 802.1P

The HG659/HG659b uses the IP address range 192.168.1.x/24 by default.To avoid conflict, to another IP address range. i.e. 192.168.3.x/24

From here I do not get a connection to the internet. Am I missing a step here?

If you could please assist it would be much appreciated.

Thanks heaps !